Security Labs SL800 Manual de instalación descargar pdf (Pagina 34)

The GTO, Inc. Technical Service Department is open

Monday – Thursday 7:30 A.M. – 5:30 P.M.

and Friday 8:00 A.M. - 12:00 P.M. (Eastern Time)

TELEPHONE (800) 543-GATE OR (850) 575-0176

FAX (850) 575-8950 • E-mail: [email protected] • www.gtoinc.com

SYSTEM TEST SPECIFICATIONS

Transformer: 120 Vac / 60 Hz input

18 Vac / 40 VA output

10 W solar panel: 18-22 Vdc / 600 mA per hour

Battery: 12 Vdc / 7 Ah

Wire: 16 gauge, multi stranded, direct burial

Motor: 12 Vdc 90 rpm with case hardened gears. The motor current range

is 2.5 to 10 A if the gate is in good working order.

Receiver: 5 Vdc / digital communication. ONLY GTO receivers can be

connected to these terminals.

Control board: Microprocessor driven. Powered by 12 Vdc.

terminal. Then activate the unit and watch the voltmeter. The drop should not be more than 1 volt.

Note: A loose battery terminal will cause the same symptoms that a bad battery will cause. Terminals should

be secure and corrosion free.

Remote control range: This will vary at each installation. (see FCC disclaimer on page 23), but generally varies

from 50 ft. to 100 ft.

• Make sure that the receiver is located above metal fences.

• Moving the receiver even a few inches can change the range of operation.

• Move the receiver as far from the motor as possible to avoid the chance of electrical interference.

• Check or change the battery in the transmitter.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 44 45

Sin comentarios

Security Labs SL800 Manual de instalación Pagina 34